Honeywell Pro TH3110D Non-programmable Digital Thermostat
This thermostat provides electronic control of 24 VAC single-stage heating and cooling systems, or 750 mV heating systems. Install the thermostat about 5 feet (1.5m) above the floor in an area with good air circulation at average temperature. Do not install in locations where the thermostat can be affected by:
• Drafts or dead spots behind doors and in corners
• Hot or cold air from ducts
• Sunlight or radiant heat from appliances
• Concealed pipes or chimneys
• Unheated/uncooled areas such as an outside wall behind the thermostat
Check to make sure your package includes the following items:
• PRO TH3110D digital thermostat (wallplate attached to back)
• Operating manual
• Wall anchors and mounting screws (2 each)
• AA alkaline batteries (2)
Remove the wallplate from the thermostat as shown at left, then follow directions below for mounting.
1 Pull wires through wire hole.
2 Position wallplate on wall, level and mark hole positions with pencil.
3 Drill holes at marked positions as shown below, then tap in supplied wall anchors.
4 Place wallplate over anchors, insert and tighten mounting screws
Download PDF Manual Honeywell Pro TH3110D Non-programmable Digital Thermostat
Related PDF Manuals:
- Honeywell T8112D Programmable Thermostat User Guide
- Honeywell Thermostat RTH230B Installation and User Guide
- Honeywell T8624D Chronotherm IV Deluxe Programmable Multistage Thermostats
- Honeywell TL7230A Electronic Thermostat User Guide
- Honeywell TrueSTEAM Humidifier
- Honeywell HCD544/HCD544X/HCD545X Camera Quick Install Guide
- Apple iPod Repair Manual Guide
- How to connect Wii to the Internet Using Coax Cables
August 12th, 2009 | by admin |